ive asked steve already but i just wanna show this vid that i took.its my 2 speed gear (1st vid) .the alum part with 4 tabs wont reach the holes.and then on my diff gear (2nd vid) it wont fit the whole plastic part like the stock gear does.where the black plastic part slides in the diff gear then u can bolt it.with this one i bolted it but in between the mount and the gear theres space ,is that ok??

[You must be registered and logged in to see this link.]

[You must be registered and logged in to see this link.]

Bad on the diff gear you need to flip it over, the flush part of the diff gear goes in first.
As for the spur gear, check your rubber bushings are not worn, you can shim the shake out from the inside of the gear.
Slight play or lose fit is fine between the spur and pinion giving smooth rotation between the 2......however too much is no good.

the 2speed was bought used and i dont think it came witht the rubber bushing..steve asked about the bushings and i cant find them..do u know the part number if theyre sold seperately??
for the diff gear i need to flip it??man i thot that black part slides in the gear heeheh,anyway how do i open the diff case?theres only 1 screw holding it and i cant take it apart..thanks pete.

It does not matter which way the diff gear mounts. You just need to line up the pinion gear with the diff gear.

Bring the 2 speed to work tomorrow. Lets see if we can match up a piece of hose for ya!

ok ill bring it ..man i fell asleep in front of the pc for like 30minutes ..heheh

it happens and I am ready to join you brotha. Im freakin tired as hell